Waterjet cutting can punch holes in titanium, stone or glass cutting all kinds of tricks, these are exhibited the waterjet own uniqueness. It did not generate heat in the cutting material, in this cold working process, it generates supersonic water arrows in the cutting surface of the material to achieve the desired results, a mixture of water and sand, the more enhanced the cutting ability . It is superior to other processing techniques, such as flame cutting, plasma processing, laser machining, electrical discharge machining, car milling processing.

The high-pressure water is produced? This basic principle is both simple and complex. Water jet from the pressure pump, high-pressure pipe, then shot out from the cutting nozzle. Very simple explanation. However, it is the result of a very complex design to produce 60000PSI pressure. In the design process at small leak will be on the parts cause damage sustained erosion. Garnet sand was mixed with such a high-speed water jet, by mixing in the mixing tubes, and then to 305M / sec speed directly emitted from the sand tube to the material being processed, and this cutting process is actually a milled cutting the process, the power and the action is generated by the water.